Skip to content

Sustainability ReferenceFreight emissions

Incoterms and transport emissions: who should report the freight?

Published 2026-10-11

Every shipment has a seller and a buyer, and often a carrier that neither of them owns. When both companies report their greenhouse-gas emissions, the same truck or ship journey should not disappear from both reports, and ideally it should not be counted as “purchased transport” twice either. The delivery term in the sales contract is the most practical clue to who bought the transport.

The idea in one sentence

The company that contracts and pays for a transport service is normally the one that reports the emissions of that service as purchased transport, while the other party may still report it elsewhere in its value chain.

What delivery terms tell you

Incoterms® rules, published by the International Chamber of Commerce (ICC), define which party arranges and pays for which part of the journey and where risk passes from seller to buyer. For emissions reporting the useful question is simply: for each leg of the journey, who hired the carrier?

The table below shows who pays each transport leg under the eleven Incoterms® 2020 rules, as verified for the Incoterms® rules section of this site from the sources listed under each rule there. Always read the term and the named place in the contract — “who pays” can change at a port, a terminal or the buyer’s site.

RulePre-carriage (to the main carrier)Main carriageOn-carriage (after the main carrier)
EXWBuyerBuyerBuyer
FCADepends on the delivery place¹BuyerBuyer
FASSellerBuyerBuyer
FOBSellerBuyerBuyer
CFRSellerSellerBuyer²
CIFSellerSellerBuyer²
CPTSellerSellerBuyer³
CIPSellerSellerBuyer³
DAPSellerSellerSeller⁴
DPUSellerSellerSeller⁴
DDPSellerSellerSeller⁴

¹ Delivery at the seller’s premises: no pre-carriage for the seller. Delivery elsewhere (a terminal, a consolidation warehouse): the seller pays transport to that place. ² Transport from the port of destination to an inland place is the buyer’s. ³ The seller’s carriage ends at the named destination; transport beyond it is the buyer’s. ⁴ Up to the named place, which can be the buyer’s premises or another inland point; any further leg is the buyer’s.

“Pays” is the cost split in the rules. Who actually signs with the carrier can differ in practice (for example when a forwarder is involved), so check the transport contract as well.

What the GHG Protocol says

The GHG Protocol’s technical guidance for Scope 3 sorts third-party transport by who buys it:

So for one leg, the payer usually reports it in category 4, and the other party, if it reports the leg at all, does so as category 9 (seller’s view, transport after the sale paid by the buyer) or as part of its purchased goods.

Why the payer, not the risk point?

The guidance above keys on the purchase of the service. The point where risk transfers matters for insurance and liability, but it is not what decides who bought the freight.

Practical steps

  1. List the legs of a typical shipment (pre-carriage, main carriage, on-carriage).
  2. For each leg, write down who contracts the carrier under your usual delivery term.
  3. Calculate the legs you buy with the calculator — one leg per mode, with weight and distance.
  4. Keep the delivery term and named place next to each calculation, so an auditor can see why a leg is in your report.
  5. Where terms vary by customer or supplier, group shipments by term in your ERP and repeat.

Limitations

The Incoterms® table summarises the cost split from the sources verified for our Incoterms® rules section; the official rules text is published by ICC and was not read for this guide. The GHG Protocol points are from its 2013 technical guidance; other frameworks (for example the EU transport emissions accounting rules based on EN ISO 14083:2023) may assign emissions differently. Check your contract, the official rules and your reporting framework before you decide where an emission belongs.

Rule-by-rule explanations: Incoterms® rules.

Sources